Corrosion Resistant Low Loss Push Pull Control Cable With Swaged End Fittings

Corrosion Resistant Low Loss Push Pull Control Cable With Swaged End Fittings

Product Description

This push pull control cable is built for machines that work in wet, salty or chemical laden air, where a standard cable seizes within a season. The core of the push pull control cable is galvanized steel wire, drawn, stranded and oiled before it enters a low friction liner, and the conduit is a corrosion resistant composite jacket that shrugs off road salt, fertilizer spray and wash down water. Because both the core and the conduit are protected, the cable keeps its travel smooth instead of turning stiff and notchy after months of outdoor duty.

Advantages

• Salt and moisture protection: galvanized core plus a sealed jacket keep the push pull control cable free of rust in coastal and winter road service.

• Swaged end fittings: pressed terminals give a high pull out strength and no looseness under vibration.

• Low loss travel: the lined conduit holds a light, direct feel even on long runs and tight bends.

• No dead zone: rigid swaged end fittings remove the free play that appears with clamped terminals.

• Long service life: the corrosion resistant jacket and the swaged end fittings keep this push pull control cable accurate over years of outdoor duty.

• Stable in cold and heat: the low loss liner stays supple from -65°F to 230°F, so the push pull control cable does not bind on a winter start.

Typical Applications

• Throttle and engine speed control on boats and gensets

• Gear shift and clutch release on trucks and buses

• Parking brake and PTO control on agricultural machines

• Valve and damper actuation in water treatment plants

• Remote control of pumps, winches and hydraulic spools

• Seat, hatch and canopy release mechanisms

Real Pictures